This unit is an aftermarket substitute / replacement for the Panasonic DMW-AC7 and DMW-CAC1 AC power adapters.
The DIG-AC7 is a plastic box approximately 3"x2"x1" (80mm x55mm x30mm) the dc output cord is permanently attached to the adapter unit and exits at an angle. (see photos)
The DC output cord is approximately 60" (152cm) long terminating with a type 3 + center male plug. The AC cord is approximately 55" (140cm) long.
The case and AC connections are not weather resistant. This unit is for indoor use only. It should perform well in studio / video capture situations where power is required for longer than the battery could provide or camera controls inactivity causes the camera to shut down on battery power.
NOTE: This is an AC adapter ONLY - It does NOT recharge batteries. If a battery is present in the camera body the CAMERA will determine whether or not any charging takes place. (see your owners manual)
The DIG-AC7 in Studio Use:
I used the unit to power the camera for much of the photography used in this post. There were no surprises. The AC adapter / camera combination stayed ON and ready to go throughout the shoot.
Cord length may be an issue depending on your situation. I needed to elevate the DIG-AC7 unit in order for the cord to reach the DC input jack of the camera body. This was not a major issue in my case, but it is something to take into consideration.
The DIG-AC7 seems to be well regulated providing a steady 8.4v DC output.
Overall the DIG-AC7 does what it's supposed to do and seems to be an entirely acceptable AC adapter alternative.
(I purchased mine from Accesory Genie through Amazon.com)
No comments:
Post a Comment